Recent content by c21fishing

  1. C

    2003 smokecraft millentia 161

    If anyone has this model on a karavan trailer can u post on how it sits on the bunks , mine doesnt seem right, one side is higher
  2. C

    bunk reinforcing

    I have a smokercraft millentia 161 on the trailer the bunks are around 8' long just wondering if this is normal to have bracket holding the bunks at the front and back only. should i try to reinforce it in the middle
  3. C

    valve handle

    how do i know if this valve handle is in the right position
  4. C

    full or empty fuel tank

    i have been reading on the web and getting mixed results so just wanted to know peoples advice and why? i have a 24gal fuel tank on my boat it will be stored outside should i leave the tank full or empty. thanks
  5. C

    prop info or advice

    i have a 16.5 alumacraft with a 70 hp evinrude vro with myself and another adult and gear im running about 6000 rpm would a 19 pitch prop lower my rpms is the 19 a good choice or should i just stick with the 17pitch that i have . thanks
  6. C

    prop help

    i have a 1989 70hp evinrude model e70tlcem i currently have a 13 3/8 x 17 prop on it i am looking to get a 13 3/8 x 19prop but i cant find on that is 13 3/8 any suggestions . thanks
  7. C

    prop selection

    i have a 1989 70hp evinrude model e70tlcem i currently have a 13 3/8 x 17 prop on it i am looking to get a 13 3/8 x 19prop but i cant find on that is 13 3/8 any suggestions . thanks
  8. C

    fogging carbs for winter storage

    i have a ttached a pic of my motor just wondering if i have to take this cover off to fogg the carbs and if so is there anything i have to becarful of or is there another way to fog them . thanks
  9. C

    not sure what this is on my boat

    i have an attached pic just wondering what this is . there is another one of these on the side of the boat . thanks 1990 alumacraft dominator cs
  10. C

    dont fog the carbs for winterizing?

    my mechaic told me not to fogg the carbs for winterizing he told me to run until it runs out of gas and spray the the cylinders only and only change the bottom end oil every second year. i have a 70hp 1989. just wondering what everyons opinions is for this . thanks
  11. C

    carb fogging

    what is the best way to fogg the carbs on a 89 70 hp evinrude . i have 3 carbs correct .do i spray in each one indiviually until the motor dies or just back and forth to each carb .
  12. C

    1990 70hp everude vro bogging at 3300 rpm

    i have a 1990 70 hp and it is jumping or bogging down at 3300 rpm if i keep it at 3200 nothing happens it runs fine . the problem DOES NOT happen all the time . it took it out today and this was the first time since May it happend. i shut off the motor tilted it up let it sit for five minutes...
See more
Top