FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Hi guys,
I've got a 13'6" wooden runabout a 1956 30hp Evinrude. I converted the motor over to a short shaft last week and well I ran the boat and by my GPS it will only run about 21-22 mph. With the motor as a long shaft it ran about 18-19 mph. The boat probablly weighs less than 300 lbs. I...
Hi guys, I rebuilt the carb on my 18 hp evinrude and converted it to a fuel pump using a 3 line pump (18-7353) and it seems to work fine. The only problem I have is I'm getting a little fuel leaking at the high speed needle adjustment. Its got new packings and I've tightened them down but still...
Hi guys, can anyone give me the part # for a fuel pump to convert my 1957 evinrude 18 hp motor to a single line? I was going to keep the dual line tank but found a hole in the bottom as I was sanding it to be painted. I just replaced ignition system,impeller, and rebuilt carb. Now all I need is...
Hi guys,
I need some help finding a " U joint boot for a Eaton Interceptor marine drive. The drive is on a 1963-65 Hydrodyne ski boat with Ford interceptor motor. Any one got any ideas where I might find one? I have ordered two but both would not work. thanks
HI guys,
I have a 1956 evinrude 30 hp that I bought last year. I just put it in the water yesterday and it would not build any rpm's at full throttle. It felt like it was under a load. I got it back to the house and the plugs had a small amount of fuel oil mix seeping out around the plugs. I...
