Re: Gelcoat and Duratec Clear High Gloss Additive
Well....here it is....a couple gallons of boatyard resin, five gallons of gelcoat and seven weeks later. I ended up using straight gelcoat cut at 25% with styrene. Turned out great, like new. Only four boats to go.
I'm a bit confused. I will be spraying a fresh coat of gelcoat with Duratec additive to a hull, below water application. Duratec says that for below water applications you must add a styrene wax. I called Duratec and asked if I could use gelcoat with wax rather than adding the styrene with wax...
I run a lodge in the Bahamas. I have four new 60hp Yamaha two strokes I'd like to install hours meters on. These are pull start motors....there is NO Battery. The meters have two leads, neg and pos. The negative is easy enough. For the positive....One mechanic said to tap into any yellow wire...
