Bondo's latest activity

you cant really jb weld the internal valley cracks, may also be one in the bottom of the bores/ crank area generally what we have seen...

To close the loop on this, as it turns out I had 3 things occurring at once. 1). The spin on fuel filter was barely hanging on...

No any 96 and up 8 bolt intake vortec will work. I did the same project on a 2004 sea ray the 090M block casting 4.3 uses some metric...

Sometimes a slight trim adjustment will make a difference.

I would recheck the alignment several times and rotate the coupler 90 deg 4 times to check alignment through the arc of coupler...

I suspect that Amazon Prop is quite a bit different from a Mercury Prop of the same Dia and Pitch. Quite a bit different, might seem...

This clip in question is the clip that holds the trim sending unit wires to the water intake hose.... For a detailed illustration, see...

I just used a zip tie on mine.

the on the fly completely takes away any question of - is it too high, or is it too low. You can put it right were you want it, on a...

no worries

Yes, aluminum doesn’t rust, it corrodes. The anodes are there to sacrifice themselves to protect the aluminum.

What he said. I haven't had to replace any that are this new (already have the updated knurled design) but it is very common to need...

I now work the parts/service counter for a big dealer, and. It never fails to amaze me that people want to install parts that rarely go...

Nope,.... It's gotta come out, or maybe slid ahead 1/2 foot, or more,....

Small update to this "little story". I changed out the 14.5x19" SS sporty prop to the same size aluminum one and tested the boat. I...