FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Kend301,
I was curious how the winter mods went. Milling the head, and improving the flow through the impeller etc.. I read about your plans last year. Any news??
I just got my boat out of the barn and it started right up. Yeah!!. I installed a new tach that I picked up on ebay. It was a...
Some good news for all who have trouble with these. I too had problems with this motor. My magnets broke and it would not start.
So through the info here I made some changes.
I replaced the flywheel with a #859241T10 also referenced #817494A2.
I matched it with a trigger #817029A9 (Reference...
I want to test the stator output and the trigger output on a sport jet 90
If you do not have a test harness (511-5207A) how can you test the CDM output. I have a DVA. Is there any way to do it without the harness?
Thanks
Kent
How do you hook up an automotive tach to a sport jet 90? Just for testing purposes, in a complete install. I want to set the idle speed and check the RPM at WOT.
While tuning and timing we had the flushing adapter connected for a couple minutes at medium pressure. we tried to crank the engine and nothing. The starter would not turn over the engine. I removed the spark plugs and water shot out of the lower cylinder. I checked the plugs and the lower...
I wnat to do some tuning at home asap but I do not have the dealer flushing adapter. Any ideas as to how to do that with any other readily available fittings at a local plumbing supply? I don't know why they did not just use standard 3/4 pipe fittings. Thanks.
Kent
My problem is similar but different to the others with sport jet 90s.
My boat 1994 sea ray Rayder engine #0e050827.
It has always been finicky to start. (only had it one season). This year I left the gas in it over winter and it would not start. I drained the gas and removed and cleaned all...
