FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I appreciate all of your help. My thought was that grouping would add more cooling surface. Going to put it back together on Sunday. Grease for orings showed up today 👍
I know you said each hole. Wondering if the top example would be better. All holes were blocked off with silicone. Thinking that was my intermittent over heat issue.
Hey all, I can not find anything in my manual about this. This head has orings and not a gasket. I pulled one head so far and all the water jacket holes were filled with silicone. I have read that it's not good. I am just not certain where I should apply silicone. Anyone have the correct answer?
Hi all, was looking for a little assistance with this. I have a 98 150 oceanpro. She will alarm and limp mode ONLY around 2300 rpm. Wot no problem. 2k rpm fine. That rpm is when the boat is plowing and will fire that overheat alarm. Neutral and refire and it's fine. Water pump and thermostats...
