FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Having some issues with this kicker motor. Took the boat out and the motor was very hard to start. Only wants to run with the choke 1/2 on. Intermittent problems with idle speeding way up, or slowing way down. Took the carb off, it had some junk in it. Now when I can get it to start gas runs out...
Does anyone have a picture of the vessel view module installed on a 40 hp? I have a brand new outboard, and I'm just trying to see how someone else mounted that module. I watched a couple vidros, but they were all bigger motors, and none of them have the same mounting areas as my motor.
I have an 83 evinrude 25 h.p. It doesn't have a knob on the low speed idle screw, and it's a discontinued item. I'm just curious if anyone has successfully replaced it with some generic knob and where you found it, or what you used.
I have a custom fabricated 16 ft duck hunting boat. It's like a v-hull, but flat bottom out the back. I bought a 1984 25hp evinrude to power it. The guy I bought the boat from said it was built for a long shaft, and my motor is a long shaft. I looked it up by the numbers, and it says long shaft...
