FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
So after I picked up a harbor feight compression tester it shows to have 75 lbs. Of compression. I dialed my air compresser in to 90 lbs. And used a rubber tip and shot air into the tester and it read 86 lbs.
Am I doing something wrong. I would expect my motor have more problems than bogging...
I have a 2001 175 Johnson last time I took it out . I notice half way through the day that at Low rpms I had to use the choke to keep it running idling around scanning fish spots . And it was spudering and popping when in neutral . At wide open it only run 4800 rpms but normally it would be at...
Well pulled tnt motor and oil came gushing out . When I move the tilt rod by hand there could possibly be a little air in the top but if I open the manual release valve and push all cylinders down when I hit the trim down they come up????(Don't think that is supposed to happen). So when I hit up...
A
So would u say it was air all the time? I don't hear air at all . I have open the reservoir so many times to let air out . I am doing it in my sleep. Lol.
Hello all!!!!! Put a new seal kit in my tilt and trim. Put it back on the boat and the trim tabs work kinda. As soon as u let off the up button it fades back down a little . Then when u push the down trim button it just hangs there until u let it go then it fades down. So when u get it all the...
Was want to know how to test a manual release valve. Is there a way before i just buy a new one. The o rings where broken when it came out. So I grabbed some out of my o ring kit . Just rebuild tilt and trim with all new gaskets and o rings. The trim works but bleeds down but the tilt won't...
