Recent content by Archer59

  1. A

    75 hp no fuel #3 cylinder

    1994 Mercury 75 hp 0G014879 On the water motor surged a couple of times as I accelerated then cleared up. Was running fine until I slowed down for a bit and tried to accelerate but could not get over 3200 rpms. To make a long story short pulled #3 plug wire while running and no change, running...
  2. A

    Need picture of inside tilt trim pump/manifold unit mercury part numbe r809901A 2

    I can find every exploded view of this tilt and trim except the pump manifold. Anyone have a pic? I will take this one apart whether I have one or not at end of season. No r in the pump number. Thanks.
  3. A

    Yes ... another tilt and trim thread.

    1994 Merc 75 hp 0G014879 The tilt slower going down than up. The fill cap shredded some pieces into the unit. I blew air through everything when it was apart. I replaced all the o-rings through out the unit. Voltage at solenoids is 11.24 for both green and blue. I'm still purging air out, I...
  4. A

    1994 Lund Pro V 1775 Tiller - center floor board removal?

    Re: 1994 Lund Pro V 1775 Tiller - center floor board removal? Middle floor board runs from back deck to about 16" from front deck.
  5. A

    1994 Lund Pro V 1775 Tiller - center floor board removal?

    I took all the screws out and the center board is tight as could be and would not come up. I removed the floor board over the live well pumps first also. Any ideas? Thanks
  6. A

    2000 Fish Hawk 1600 / 40 hp Merc Tiller

    Just bought my first Crestliner. Unfortunately... I bought it and stored it on the same day. No room for another boat in the driveway. ONLY 5.5 months till I'm back on the water :( Anyone else running this combo?
See more
Top