Recent content by alien4fish

  1. alien4fish

    Shifting Issues Throttle in full reverse but prop spinning In nuetral

    Hi forum Here are the Specs............mercruiser 260 Fresh repower mercruiser 260 outdrive fresh impellar kit including impellar housing top and bottom. When I pulled the the motor I put the throttle in fwd postion and pulled the drive, rebuilt the motor, and replaced the impellar, I had...
  2. alien4fish

    New long block, Water still getting in the oil

    Ok Board, its me again, Bondo, Don S. I need the pros to chime in cuz im stumped at the moment Ok Here is the short list New long Block............ I havent checked the numbers on the block yet but I believe it to be a 1977 or so................Chevy 350/Merc260 with about 1 hour of run time...
  3. alien4fish

    removing the harmonic balancer on a Mer260/chevy350

    just like the tittle says,I pick up my long block Friday.and i will begin the switch over of all my Marinized parts, and from what i have read I need a special tool to pull the Harmonic balancer off the front of the motor. Is there a trick to pull it off without any damage as its going on the...
  4. alien4fish

    Barr exhaust manifold help?

    Hi Forum, Im in the middle of a repower and today was the day to pull the outdrive, disconnect water intake,shift cable assy.alt. etc. to pull the motor everything is moving along well dispite a few small hang ups, So we have everything 90% ready to go except for 1 of the 2 thru bolts at the...
  5. alien4fish

    HELP!!! no power under load oil in the bilge!!

    Hi forum, Here is my delima, i just purchased a 1981 sea ray with a Mercruiser 260 and merc alpha1 out drive. I checked out the boat at the guys house and it started right up and ran well in the driveway, the engine reved well, no knocks no pings. The tilt drive had a leak in the clear line...
Top