awesome BIG BIG thank you I will pass along all your helpful informations to the Shop owner. I welcome any feedback and will continue to log in from time to time to read if anyone added more info have a great day
Thank you
yes I know what box your talking about some said it was my neutral switch most likely I got wrong info will check that box real good for ref number and wire ID. what about the gear for propeller if it was touched for example lighter boat etc could that potentially cause an issue down the line?
Good day. so I just came back boat in the water OUF when I discovered the bugging down at 2000 RPM my my I disconnected the trottle shifter cable and operated manually Wow hold on to the seat the Boat hit 3000 rpm and I could have given it lots more therefore I think its a link and since and...
I can't thank you enough on your help my my.... I'm going to my last problem with this engine A arm advance timming WOT. when I manually pull forward the main trottle arm given full trottle C my advance arm A goes opposite to reaching the BTDC 22deg therefore may bugged down on the water again...
bade on AI :)
Based on the photo, your engine has a 200 HP (2.4-Litre) powerhead. A previous owner likely swapped the block or the entire powerhead onto your 1982 150 HP midsection.
Measurement Breakdown:
Bore Size: The caliper reads exactly 3.375 inches (3.3" on the slider + 0.075" on the...
the 858-7790 is stamped bottom engine block below cylinder no 5 also added a gasket that was replace perhaps with the caliper indication the size could help
Thank you so much for your time on this.... last year needed parts and a local mercury repair and sale store looked up that serial number and found it in the mercury data base as a 200hp not that it makes any difference to me. I will upload head picture etc standby :)
Hi. only want to use this engine on my 25'x8' aluninum tank :) I have to say Im still not 100% sure perhaps that flywheel cover and flywheel is original and should go back and use the flywheel cover and line up TDC 2deg BTDC using the flywheel markings and not use my Mickey Mouse indicator I...
To add I'm wondering perhaps it was only the outter 8 bolts that should have been touched to move the ring that has the timing marks to line up with my mickey mouse homemade indicator until the original arrive ? and have not touch the flywheel center nut
Hi Captain. the reason I'm in this forum is for the best advice I could find and was skeptical of the suggestion I received locally and I do trust your suggestion the issue is because this engine is a custom built prior to me it is very difficult to find info as to what I'm trying to achieve...
