Recent content by AaronR650

  1. A

    Shift position way off

    Did what you said, now It shifts correctly, however it will not go into neutral from reverse. It needs to be put from reverse to forward then back to neutral. I tried adjusting the shifter arm by loosing the two screws but there was almost no play. My second issue is, At full throttle I'll be...
  2. A

    Shift position way off

    Will definitely give that a go!
  3. A

    Shift position way off

    I might need to be more clear sorry. I might need to be more clear sorry. The lower unit shifts into reverse, neutral and forward just fine. However to go in reverse, prop spins backward, the shift lever is in the neutral position, and neutral for the lower unit is between the neutral and...
  4. A

    Shift position way off

    There is zero adjustment whatsoever? because the lever will not push back to reverse while the rods are connected.
  5. A

    Shift position way off

    I have a 84 Evinrude 25hp Electric start(Model number E25TECRD). In the levers neutral position, gear box is in reverse... Neutral is somewhat about 1 o' clock and forward is at about 2:30. I can't find out how to adjust the linkage length. Other videos people just twist the lower units shift...
  6. A

    56 Evinrude looking for a gasket.

    Evinrude fleetwin 7.5 1956 model number 7520. I am searching for the powerhead base gasket. Ebay has no results and marineengine shows a different style of gasket in a set.
  7. A

    MerCruiser 140 HP 2.97 L Overheating Issuses?

    I had purchased a fairly used boat(SeaRay 87) and found that it experiences overheating. Upon further inspection several problems were discovered. The exhaust bellows were completely gone and only a little bit of rubber found at the connecting points, the out drive and transom. The inlets for...
See more
Top