I was wondering if anyone would have some info on this engine, gasket placement, o-rings bolt torque specs, full diagram, anything they could share.
Thanks
So last weekend I had some issues of the engine bogging out at 2-2500rpm and at best 5-7mph I haven't had much time to really dig into the carb system on the engine, I have installed a new stator, trigger and regulator on this motor. Here is what is happening now, I sprayed some cleaner into the...
So is it possible to remove the shaft seal without removing the shaft, I picked up a 76 MonArk McFast and I worry the shaft seal maybe bad, it has 400hrs on it, the lower unit was empty and the prop has grease on it. I do not know if this is from being a 2stroke or not. Also does the oring on...
I have an older boat as the title suggests, the stern unit predates alpha and bravo units, but what I want to know can tilt/trim be added to an older unit?
I am doing some work, and undoing someones work and this boat has two live wells, the both have 1-1/4" inlets that are wide open and 3/4" lines that are a little higher up, The one up front both lines have plugs in them, the back one the 1-1/4" is open and the 3/4" line is open and is higher in...
