FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
motor was removed and reinstalled back on boat. my problem is when i rehooked the throttle and shift cables controller would go into forward and not move any further. how do i start all over to adjust the barrels on the cable ends at the motor. should controll box be in nuetral or forwad.
top is removed, what is the best way to brace top of hull before removing floor and stringers. was thinking to clamp 2 by 4's across top to keep width so top will fit back on. any suggestions
do i need to support the hull before cutting out the floor and removing stringers. transom is out and stringers are cut back 6 inches along with the bulkhead.
replacing transom with wood, i need to know if i can cut the stringers and bulkhead back and then cut new wood and fiberglass in. will this be strong. any ideas. im not replacing stringers or the floor.
