1960 Johnson 10hp QD-21 lower crank seal

Isaac91303

Recruit
Thread starter
Joined
Sep 11, 2018
Messages
4
I am wondering if anyone can help me with the proper parts assembly sequence. The parts list shows an o ring between the lower bearing and the actual crank seal. It does not make sense the way it is shown unless the O ring actually goes in what looks like a groove in the lower bearing instead of between the bearing and the seal along with the two spring washers, spring and the snap ring.
 

Attachments

  • photo300863.gif
    photo300863.gif
    35 KB · Views: 0

Joe Reeves

Supreme Mariner
Joined
Feb 24, 2002
Messages
13,262
That's not a O Ring... it's a Quad Ring, a special shaped seal of sorts. It goes inside of the carbon seal #5.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
If you are looking at item #7, that o-ring goes in a groove in the crankcase, around the O.D. of the bearing. You can't see it without splitting the crankcase.
 

Joe Reeves

Supreme Mariner
Joined
Feb 24, 2002
Messages
13,262
If you are looking at item #7, that o-ring goes in a groove in the crankcase, around the O.D. of the bearing. You can't see it without splitting the crankcase.

Yeah.... That too! :)
 

Isaac91303

Recruit
Thread starter
Joined
Sep 11, 2018
Messages
4
I figured out that 6 went into 5 the seal. 7 was my question about where it went. Thank you all very much for your help I appreciate it.
 

Isaac91303

Recruit
Thread starter
Joined
Sep 11, 2018
Messages
4
I figured out that 6 went into 5 the seal. 7 was my question about where it went. Thank you all very much for your help I appreciate it.
 
Top