83-- 70hp Johnson stalls WOT

stoekd3

Recruit
Thread starter
Joined
Jun 25, 2018
Messages
5
My boat starts first try always. It has been running well until last trip. It ran for 10 mins then died at WOT. it started right back up, and ran for about 3 mins then died again at WOT. Started back up and made it back to the dock at low rpm.

I took her out today to pump the primer while my son drove. It was losing HP and ran for about 3 mins even when i was manually pumping. we started it back up and drove back to dock at low rpm.

at home she starts and runs on the bunny ears.

I recently ran new fuel lines, only use Rec 90, I checked the fuel/water separator tonight and it was fine, new fuel tank. Spark plugs were checked about 3 months ago.

My thoughts are maybe:
1. Fuel diaphragm
2. b.c it was slow today maybe a torn head gasket


I would appreciate any input, thanks guys
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Sounds like a possible overheat.

or fuel tank not vented.

Did it ever run well after the work and new tank?
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Step 1 is a compression test. Report numbers. This is a must do...
 

stoekd3

Recruit
Thread starter
Joined
Jun 25, 2018
Messages
5
Sounds like a possible overheat.

or fuel tank not vented.

Did it ever run well after the work and new tank?

It has been running well for about 3 weeks, I did the fuel and tank about 2 months ago.

Interesting you said overheat, I changed the thermostat about 2 weeks ago, the alarm went off but once i put the new thermostat in the alarm has not gone off, the block has been warmer than usual, which is why I thought torn head gasket/water jacket. but the alarm hasn't gone off and there is no smoke.

i made sure the tank was vented properly
 

stoekd3

Recruit
Thread starter
Joined
Jun 25, 2018
Messages
5
I should add, there was no smoke or alarm going off. I do have a temp gauge that seems off but the heads seemed really hot. The boat is also only used in salt water. we do a good job or flushing it after every use.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Depending on compression results, revisit overheat issues. If by "really hot" you mean too hot to touch, it's overheating. Normal temp is 140F, give or take. Approaching or hitting 160F is overheating.
 
Top