Johnson 115 dying at higher throttle

dirtyb15

Cadet
Thread starter
Joined
Aug 15, 2016
Messages
17
Hello all, i have a 1979 johnson 115 . Last season it was starting to cut out when running at full throttle. (Like it was out of fuel). Bulb was not flat and throttling back would get it running again. I took the small fuel filter screen off the line that hooks up to the pump and it was a little dirty, cleaned it, but did not help. Well had it out this season for the first time and now it cuts out at anything above 1/4 to half throttle. Still comes back fine if i throttle down. Idles and starts great. Just looking for ideas before i start tearing into things. I noticed there was small piece on top of the metal gas tank made by stueby manufacturing. Is that possibly a filter?

Maybe just carb is gummed up a little?
 

tonkit

Cadet
Joined
Apr 1, 2016
Messages
22
When my 115 merc was doing that I Reddit carbs, replaced filters, changed fuel lines etc. Finally ended up replacing my priming bulb ( which was less than a month old by the way). Really frustrating when a part that was new turns out to be bad! My bulb seemed to work fine but had a very small air leak. It never leaked any fuel and it never sucked down. Might not be your problem, but is a relatively inexpensive place to start.
 

fireman57

Captain
Joined
Aug 24, 2004
Messages
3,811
Have someone pump the primer bulb a few times when it does this. If it picks up replace/rebuild the fuel pump. You can also try hitting the primer and see if it picks up. If it does clean/rebuild the carbs. Easy job. If you don't know when they were cleaned last I would start there.
 

dirtyb15

Cadet
Thread starter
Joined
Aug 15, 2016
Messages
17
Have someone pump the primer bulb a few times when it does this. If it picks up replace/rebuild the fuel pump. You can also try hitting the primer and see if it picks up. If it does clean/rebuild the carbs. Easy job. If you don't know when they were cleaned last I would start there.

Okay, thanks for the info. I have never had the carbs apart and i've had it for 10 years or so. Guess it would not heard to rebuild them.
 

dirtyb15

Cadet
Thread starter
Joined
Aug 15, 2016
Messages
17
When my 115 merc was doing that I Reddit carbs, replaced filters, changed fuel lines etc. Finally ended up replacing my priming bulb ( which was less than a month old by the way). Really frustrating when a part that was new turns out to be bad! My bulb seemed to work fine but had a very small air leak. It never leaked any fuel and it never sucked down. Might not be your problem, but is a relatively inexpensive place to start.

Well, tried this first and running great now. Thanks! Thanks everyone else for the suggestions as well.
 
Top