1967 Johnson Golden Meteor 100

JT59

Recruit
Thread starter
Joined
May 2, 2018
Messages
1
Just bought the boat yesterday(1967 StarCraft 18') and need to get engine to crank and fire. Was thinking about cleaning carbs, but I have never seen an inline 4 brl 1 piece cab like this before. Of course, I've never worked on an engine this old. Until I get a manual, any advice on resurrecting this old girl from a several yr sleep. Did comp check using emergency pull rope. 4 pulls for each cyl gave 112-120. Any advice very appreciated. I would like to keep this engine as it is the original with boat since new in 1967
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
My advice is "Whoa". Parts for that carb are hard to find and outrageously expensive if you do find them. The main gaskets are very complex and would be very difficult to make. The floats require a special tool to set. So, leave the carburetor alone until you are darn sure it needs to come apart. Remove the four slotted hex head plugs to see if there is fuel gum behind them. If not, stay out of there until last resort. Carb kit is part number 382059, $211.50 from one popular source. Float valves are $58 each, and it takes four.

Your first consideration should be the ignition system. Do you have spark? That motor has the Prestolite Pulse Pack battery CD ignition. Very easy to damage and $$$$$$ if you do (about $400). The rest of the electrical system must be in perfect working order before even attempting to start it.

You really need the factory service manual, although it is outdated also. It tells you to use obsolete test equipment.
 
Last edited:

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Just another possible gotcha----the shift switch in the remote control costs three to four hundred.
Better stand back and evaluate this whole project and decide if it is what you really want to do.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
OK, by now you could use some good news. If the pulse pack is shot, you can convert the ignition system over to good old fashion coil and condenser and automotive coil.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
F_R beat me to most stuff, about the cab and powerpack

New Impeller, change the gear oil, IMPORTANT- Precision Blend is the recommended Oil. Type C is what Precision Blend used to be called. There are several so-called aftermarket 'Type C' oils available, but some are not compatible/usable in Electric Shift gear cases.
Oil Mix is 50:1 TCW-3
Engine:
89 cubic inches
100hp @ 5000 rpm
WOT range 4500 - 5500
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Install the 1966 model distributor.----Coil , 2 sets of points and condenser.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
That distributor was used on a number of models.----Up to the OP to research and find one within his budget and decide which way to go.
 
Top