1971 Johnson 25 hp need help please engine throttles up byitself and dies

tntitans

Cadet
Thread starter
Joined
Mar 24, 2018
Messages
6
I have a 1971 johnson outboard 25hp when i went fishing the other day I started the motor and was a quarter way into the throttle then the motor sounded like it went full throttle and it died . I waited a miniute and started back and as soon as the engine started the motor sounded like it was on full throttle then stalled out
 

tntitans

Cadet
Thread starter
Joined
Mar 24, 2018
Messages
6
it's almost like its leaning out or something. the carb was rebuilt about 2 months ago
 

Vic.S

Rear Admiral
Joined
May 4, 2004
Messages
4,721
Fuel flow or pump problem ??

Try pumping te bulb to see if that keeps it going. If it does then it pretty much rules out a carb problem and confirms the above.
 

tntitans

Cadet
Thread starter
Joined
Mar 24, 2018
Messages
6
when i pump the pump on the fuel line i can hear air a the quick connect on motor would that cause this issue
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
You should not hear air.-----Replace the o-ring in the connecter.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Maybe look at all throttle linkages to see if anything is broken.-----At the bottom of that shaft on the side of the block is a plastic pin that has been known to break.-----Sorry I am not there to look at this motor.----Sounds like there is an easy fix !!
 

RCO

Petty Officer 1st Class
Joined
Jun 15, 2016
Messages
350
A broken flywheel key can cause that also .
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
There will be " no spark " on that motor if it has a sheared key !!
 

RCO

Petty Officer 1st Class
Joined
Jun 15, 2016
Messages
350
That motor has the universal magneto, it will still spark with a sheared key depending on the flywheel position. Just throwing it out there, I have seen it many times, and it is easy to check.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Flywheel out of position due to a sheared key means no spark as points open at the wrong time.----Electronic ignition will have spark with a sheared key.
 

tntitans

Cadet
Thread starter
Joined
Mar 24, 2018
Messages
6
today I started it in a barrel when it went to lean out or run wide open byitself i pump the prime bulb real fast it slowed back down and idled i done that three times so i think it is running the bowl empty the float seems to be operating correctly would that be a indication of a bad fuel pump
 

Vic.S

Rear Admiral
Joined
May 4, 2004
Messages
4,721
today I started it in a barrel when it went to lean out or run wide open byitself i pump the prime bulb real fast it slowed back down and idled i done that three times so i think it is running the bowl empty the float seems to be operating correctly would that be a indication of a bad fuel pump

It might be a bad fuel pump or it might be due to air being drawn into the fuel line. One of the connectors is the most likely place for that to happen if the O ring seal is getting tired.

If you have to overhaul the fuel pump refer to LeeRoy's ramblings at
http://www.leeroysramblings.com/Outboard Motor Related/OMC outboard related articles.html
 
Last edited:
Top