1963 CD-20C 5.5 pulling the power head

cincyparrothead

Recruit
Thread starter
Joined
Jun 27, 2017
Messages
4
Hello all,

Working on my first boat motor. Previous owner said it needed a lower seal kit. I have watched videos about pulling the power head and I have removed all of the necessary bolts and disconnected the shift linkage. None of the videos show removing the choke lever and the richness knobs. What is the best way to accomplish that?
 

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
?? You don't have to remove the carburetor or parts of the carburetor to remove the powerhead. Once the powerhead is off and the shift linkage is disconnected, and the lower unit bolts are removed, the lower will drop right down.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
?? You don't have to remove the carburetor or parts of the carburetor to remove the powerhead. Once the powerhead is off and the shift linkage is disconnected, and the lower unit bolts are removed, the lower will drop right down.


Sure you do---on a 1963. They stick through the front of the lower cowl. The carb knobs simply pull off, perhaps a bit of screwdriver-pry help on the outer one. If memory is correct, the choke knob is held by a pin through the end.
 

cincyparrothead

Recruit
Thread starter
Joined
Jun 27, 2017
Messages
4
Knobs pulled right off and I was able to remove the power head and the lower unit. The bolts holding the gear housing together seem stuck so I've been soaking the top with pb blaster. These are slotted heads so I need to get the right size Philip's for the job. Thanks for the help.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
If you haven't pulled the clamshell apart yet, you can pressure test the unit pretty easily -- helps locate leaks. 6-8 lbs through the drain or fill hole, rigging something to make the unit airtight. Do it in a tub, and look for bubbles to isolate the leak(s).

[edit. 6-8 lbs probably a little too much. try 4 or 5 lbs. don't need much.]
 
Last edited:
Top