Overtighten Reed Plates????

Fullspeedahead

Cadet
Thread starter
Joined
Jun 6, 2016
Messages
20
can you overtighten the reed plates and would that cause issues for an easy start? On a lets say 1964 evinrude 18hp model number 18402?
 

GA_Boater

Honorary Moderator Emeritus
Joined
May 24, 2011
Messages
49,038
can you overtighten the reed plates and would that cause issues for an easy start? On a lets say 1964 evinrude 18hp model number 18402?

Fullspeedahead

This is your new thread about reeds. Take a look at the Help Tip on top of the page. Starting a new thread is the best way to get help. much better than tagging an old thread on a different subject.

2012 thread---------You should start a new one

:thumb:
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The reed valves are very reliable and if closed at resr have little to do with ease of starting.----If your motor is hard to start look for other issues.-----Do this test.----Does spark jump a gap of 5/16" , yes or no ?----Are you turning the throttle control to the nuetral stop or lining up the word START on the grip ?
 
Top