Sierra International 18-2623 Question

golson

Cadet
Thread starter
Joined
Mar 22, 2016
Messages
19
Hello Boaters,
I have a 1999 Johnson 150 and replacing the seals due to water in lower unit. I bought the Sierra International 18-2623 kit but it has seven seals in the kit. I thought the lower unit from the manual I have only has three. Two in the carrier and one in the upper drive shaft under the impeller. Is there other seals to replace and where are they. Thanks and any help would be greatly appreciated. I got my lower unit out and want to be back on water this weekend. Thanks
 

bob johnson

Rear Admiral
Joined
Feb 25, 2009
Messages
4,306
I think the kits will apply to several different units.....and some of the parts aren't used....as they would go to a model you didn't have....

bob
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
If it were mine, think I would first test it to try and locate the leak. Can rig a pressure tester, and test it in a tub of water (leg off) -- look for bubbles. Might save some time, anyway.

I use a small foot pump with the inflation needle through a piece of gasket material. About 8 lbs or so -- not much pressure.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The shift rod o-ring is simply pried out and replaced.-----On some they have gone to 2 o-rings for the shift rod.
 

golson

Cadet
Thread starter
Joined
Mar 22, 2016
Messages
19
The shift rod o-ring is simply pried out and replaced.-----On some they have gone to 2 o-rings for the shift rod.

Hey thanks for the support. I got all seals replaced in drive shaft and prop assembly but when I took the shift rod out there were no 2 seals or o-rings. The housing where the rod goes through looks like one piece and no seals in there so I assume I need to use the two rubber o-rings. Do you just slip the O-rings over the rod while installing on the lower unit?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
?????----No , there is an o-ring in there !!-----You pry it out and slide a new one in there .-----Like I said newer motors have two 0-rings in there and a replacement cover would have two 0-rings.---You need to examine this stuff carefully.----Pressure test the gearcase before putting oil in there.-----Mistakes will be costly !
 

golson

Cadet
Thread starter
Joined
Mar 22, 2016
Messages
19
I am at work right now. I will post later. Thanks for checking on me.
 

golson

Cadet
Thread starter
Joined
Mar 22, 2016
Messages
19
ok i am at home and this is the last seal to replace. can someone tell me how to get this o-ring out easily? The housing seems real tight and hate to damage it.
 

Attachments

  • 20160324_161442_resized(1).jpg
    20160324_161442_resized(1).jpg
    155.5 KB · Views: 0
Top