Generator for 1964 Johnson Evinrude 60 horse VX-10s V4

pen-xv

Cadet
Thread starter
Joined
Aug 25, 2015
Messages
15
I am attempting to nail down a means to install a generator for this engine. It seems that I've found an appropriate generator, and voltage regulator. The difficulty is connecting to the crankshaft of the engine. With this engine, there is one pulley that drives the magneto/distributor. Can I simply put another pulley identical to that under the flywheel, or is there some other way to drive the generator?
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
The generator kit included that second pulley. It is a bit different than the one driving the magneto belt. Part number 305681. It is available. See your friendly local Evinrude dealer.
 
Last edited:

pen-xv

Cadet
Thread starter
Joined
Aug 25, 2015
Messages
15
Thank you. That's very helpful! Now, does this pulley replace the magneto pulley altogether, or is it simply bolted on below it? Are there any special bearings, spacers, washers, or bolts that are required to make it function smoothly? I can't seem to find any sort of parts diagram to confirm this.
 
Last edited:

pen-xv

Cadet
Thread starter
Joined
Aug 25, 2015
Messages
15
The generator kit included that second pulley. It is a bit different than the one driving the magneto belt. Part number 305681. It is available. See your friendly local Evinrude dealer.

Thank you. That's very helpful! Now, does this pulley replace the magneto pulley altogether, or is it simply bolted on below it? Are there any special bearings, spacers, washers, or bolts that are required to make it function smoothly? I can't seem to find any sort of parts diagram to confirm this.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
No Title

Bolts on below the magneto drive pulley
 

Attachments

  • photo229048.jpg
    photo229048.jpg
    123.8 KB · Views: 1
  • photo229049.jpg
    photo229049.jpg
    212.3 KB · Views: 1
Top