Bolt torque problems: advice or help please

jhud

Cadet
Thread starter
Joined
Aug 17, 2014
Messages
14
I am reassembling my 95 evinrude 90 and I can't even get close to some of the torque specs without the bolt feeling like its starting to strip in this soft aluminum block. I think the crankcase flange are 60-80 lbs, bearing retainer plate screws 120 -145 and crankcase heads 120-145??? I am using new bolts or screws and ran a tap through some. I have already striped a couple of these. How can you get such I torque on aluminum ?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
???-----Never had a problem.---Are you aware of the difference between inch lbs and ft-lbs.-------------???
 

nwcove

Admiral
Joined
May 16, 2011
Messages
6,293
^^^ i also think the op is confusing inch lbs with foot lbs. ......120-145 ft lbs on a head bolt??? yikes!!!!
 

jhud

Cadet
Thread starter
Joined
Aug 17, 2014
Messages
14
OH....... well I do now. Feeling a little dumb, I never noticed the in.lbs in the book until now.
Thanks
 

Fun Times

Moderator
Staff member
Joined
May 16, 2009
Messages
9,458
OH....... well I do now. Feeling a little dumb, I never noticed the in.lbs in the book until now.
Thanks
That's okay because it is an easy mistake to make that could of cost you dearly. Glad you asked and someone was able to help you figure it out.:)

Good luck.:)
 
Top