Hi All,
Just picked up my new/old 15ft centre console.
I have a small problem in that,the area behind the back seat is not wide enough to fit your traditional long/wide and flat fuel tank.So its currently chewing up good fishing room on the floor of the boat,
I dont have the funds to get a custom ordered tank at the moment so i was wondering Can i buy a upright Plastic jerry can and change the fitttings over to this,which will then allow it to fit where i need it to,Will the motor still be able to overcome gravity and pull fuel 2 ft up to the connector and if so,What glue/resin can i seal the fittings to the tank with that wont react to the plastic.
Thanx
Adam
Just picked up my new/old 15ft centre console.
I have a small problem in that,the area behind the back seat is not wide enough to fit your traditional long/wide and flat fuel tank.So its currently chewing up good fishing room on the floor of the boat,
I dont have the funds to get a custom ordered tank at the moment so i was wondering Can i buy a upright Plastic jerry can and change the fitttings over to this,which will then allow it to fit where i need it to,Will the motor still be able to overcome gravity and pull fuel 2 ft up to the connector and if so,What glue/resin can i seal the fittings to the tank with that wont react to the plastic.
Thanx
Adam