Lubak572
Petty Officer 1st Class
- Joined
- Jan 4, 2018
- Messages
- 235
I have leak in my outdrive- there was milky oil when i drained it. I am going to reseal it. I have a service manual and I bought both the upper and lower seal kit (VP# 3850594 & 3856002) and the 3855955 spanner. I want to tear it apart and inspect everything and change all the seals. What other special tools are needed? I don't plan on changing any bearings or gears- unless needed. Drive ran and shifted fine just had water in it and is leaking. It is off an 2001 and had 330 hours on it. I figured i would go thru it all. How hard is this job? I believe I have to set the rolling torque- just rather not get into setting up gear lash/patterns. I have already pulled the drive and separated the upper and lower halves.