When i started my resto project i had no idea how to put my transom in so i did what i thought was a good job. However i have voids between the transom and the outer skin. can anyone tell me how i should go about filling in the voids? Is there a real chance of seperation? My boat is a 73 Newman CH. What I did to put in the transom was to put CSM on the transom then a few days later i sanded it down and put a lot of resign on the transom and the skin of the boat. Then i put plywood on both side of the transom and clamped it in the best I could. Before i found the voids i had already replaced the floor so pulling the transom back out is not not really an option. By the way if any one ask foam can really blow your floor out, atleast part of the way out anyway. So as you can see i have made my fair share of mistakes. Before I started this project i had never seen or heard of anyone rebuilding a boat so all this is new to me.
Thank You
Thank You