Search results

  1. H

    1974 evinrude 50 hp-50473m

    had an old motor given to me by a friend,had not been run in 2 years,however when it was being used it was maintained and in running condition when it was abandoned.The motor was not locked up and I had it running in about 30 min.It will not shift out of neutral.The shift shaft is free,I can see...
  2. H

    johnson powerhead swap

    will an 89 johnson 115 and a 94 johnson 115 powerhead swap out?will the powerhead off the 89 fit on the 94? Thanks in advance(they are both 20 inch shafts
  3. H

    14.5x19 aluminum vs 15x17 stainless

    I have a 1976 seacraft masterangler with a 1995 johnson oceanrunner 150,the performance i'm looking for is a little better fuel milage the 14.5 x 19 alum is on there now and its got great hole shot and throttle responce oh yeah I have no tach.Will the larger diameter less pitch of the 15 x17...
  4. H

    need help propping aquasport 21.5 with merc 1994 175

    the prop we have on it is a 14.5 x 17 3 blade and we definately need a better hole shot any suggestions? thanks Wayne
  5. H

    yamaha 115 4 stroke controls(2002)

    heh im swapping motors for a friend of mine.The yamaha came off of a 20 foot cc,and its going on a 18 ft side console.The side console had a johnson 90 on it.After swapping cable ends and a lot of head scratchin.It seems that the throw or distance traveled of the johnson side control lever is...
  6. H

    snapper season opening?

    my son says the season opens june 1.is this for the atlantic as well as the gulf
  7. H

    broken bolt

    Broke the bolt next to the sparkplug hole that holds the head cover then broke the snap on screw extractor off in it,got pretty frustrated then and tried something else that didn't work.Is there a chance that I can fill this boogered up hole in with jb weld or something like and drill and tap I...
  8. H

    help me id this motor

    its a johnson 90,it was vro,and I've discovered water intrusion into #4 and maybe #3 cyl,there are no model #s in the usual places.The only distinguishable number is the little silver looks like aluminum insert on top of the block with the number R8175072 and some numbers stamped into the top of...
  9. H

    1992 225 johnson fuel pressure

    can anyone tell me how much psi the vro fuel pump generates on a 225 johnson
  10. H

    fuel leak 1995 150 oceanrunner carburated

    Where would my motor be leaking if there are no visible leaks at the carbs or fuel pump or anywhere under the cowl yet the fuel bulb will not pump up firm and fuel will run out the rear of the lower cowl and down the midsection,the motor seems to run fine just don't like the idea of wasting gas
  11. H

    johnson 90 v4

    this motor has got me stumped it will run great wot for about 60 seconds then bogs down.I've cleaned carbs,checked compression replaced fuel lines,new filter,new plugs,I think its a fuel issue because when i hit the choke when its starting to stumble it will help.it has the vro disconnected and...
  12. H

    force 120 (chrysler)

    trying to help a friend out his force 120 tilted up by itself when he was washing it out after using and shut off.now it wont turn over or trim from the controls.if i turn the key on and jump across the starter solenid it will crank and run fine and if i straight wire the trim motor that works...
  13. H

    idle air jet

    I need to richen up my idle air jets by 2 thousandth in a 1997 merc 200 offshore.Does anyone know a source? thanks
  14. H

    merc 200 hp carb 1997

    my motor is doing what i"ve read some other guys have done, bogging down for a few seconds then taking off sometimes it takes a couple of tries so I just started the decarb process and when I started spraying the Quicksilver product in the carbs I noticed the top starboard carb seemed to be...
  15. H

    gas tank roblems

    swapped out some concrete work for some help in restoring a 1972 seacraft .They installed a new fuel tank and glassed the floor in.My engine will not pull fuel from this tank (aluminum) I have allready siphoned about 2 gallons of crap out of it until i,m getting nothing but clean fuel,changed my...
  16. H

    no reverse

    1997 merc 200hp 25 inch shaft,changed waterpump and it doesen,t want to go into reverse.what did i do wrong
  17. H

    initial startup

    mercury 1997 200.Purchased this motor to put on my project 20 ft seacraft.Do i need to do anything special to premix,can i leave the oil injection hooked up and premix, to run long enough to check this motor out? What is the most cost effective way to swap it over?There are 2 oil tanks one in...
  18. H

    bbs

    One of my lower carbs is pouring fuel out of the spot where that little bb is supposed to be. Whats up with that?
  19. H

    v 150

    where can i find an exploded view of the cowl assy for a 1983 v 150 so i will know if i am ordeing the right parts?I need some bracket parts. thanks
  20. H

    reel lube

    lousy weather for fishin so i thought i would try my hand at troubleshooting a couple of old penn reels i used for teasers. found a schematic for the reels but i dont have reel grease. is there a automotive grease i could use [trailer bearing grease]? got the parts soaking in limeaway right now.
Top