So I did the adjustments and it works great in forward and I can get it to go into reverse but I am not get any throttle in reverse. It just feels like a hard stop as soon as it gets into reverse. If I put it in the high idle/start position using the button on the controls I can get full...
Would you happen to know shift rod height for the 112 extra long shaft, some charts say 26 1/4 and others 26 27/32? Also, do you adjust cables while in neutral or forward? My manual states in forward but all posts I read say in neutral. It is a surface binnacle mount controller if that makes a...
Is this linkage supposed to twist like this in picture with red circle when in forward WOT? When it is in neutral it mates back up with the control cable like in 2nd photo.
I replaced my water pump and now trying to get the linkage connected properly. I slid the pin mechanism back through the linkage but is it suppose to slide through the other hole on the starboard side of the shift rod? Right now I can get it to shift but this black bracket seems to be bending...
Sorry it has been so long, I was finally able to take the boat out recently with the new relay. It seems to be working fine now the few hours we had it in the water. Thanks a lot!
I have a 112 johnson, the motor has been great so far since i owned it but on my last trip out last year the motor would not stop trimming down. I eventually removed the green and white wire from the plastic box after it was in the water as I didn't have to worry about depth. Anyway, is there...
So I sold my boat to a friend and of course it won't idle after telling him the boat has never had an issue for me. Anyway, the boat wasn't used much the last few years but it was used twice last year and it did idle fine my last time out. I fogged the engine and I did put seafoam in the tank...
I have a water cooled rectifier on my 95 Johnson 112 engine. I want to make sure that it is working properly since I am not getting a charge at the batteries and my tach is also not working. All the instructions and videos I have read has the rectifier removed from the engine and being tested...
Hi! I have a 95 112hp engine that isnt providing any juice back to my batteries. My first guess was to check my rectifier since my tach isnt working either. Anyway, I looked all over this engine but cant seem to find one. Did these models have rectifiers on them? I looked them up on the...
I want to make sure my shift rod height is correct. Can someone verify that 21 1/4 inches is what I am supposed to have for a 95 Johnson 112? Thanks in advance!
So I got a 03 Merc 90hp ELPTO that I replaced the swivel pin on over the winter because it was really worn out. It wasn't too bad considering i had to remove the power head, midsection and lower unit but now its all back together and I had it back on my pontoon boat and this weekend I was able...
