Latest activity

I will do that although I want to note that with the rubber plug out the motor runs just fine, gets my little boat up on plane. I would...

check compression, sounds like it is having a problem with the water back pressure when dunked(submerged)

91psi cold on both cylinders. Reading is from a gauge that consistently reads low as well, so guessing probably 100ish.

I checked the timing and it's at 8 btdc and it advances about 34 degrees with throttle. This was on my driveway though. I will get a...

My numbers were all in the low 90's not to long after a complete rebuild. I was told not uncommon on those old crossflows.

when you figure out what you have i can dig a bit deeper in the trouble shooting but based on your post i'm guessing a dual solenoid set...

Starts and runs very well, idles good but a little high at 800 rpm. Bow high should be a trim issue that can be corrected unless there...

My numbers were all in the low 90's not to long after a complete rebuild. I was told not uncommon on those old crossflows.

i did find my manual, it does not list the 80 hp however the trim system should be the same. Below are some pics, need to determine...