Yam 150 wiring

[esteym]

Hi all,<br /><br />I'm going to wire my boat (once my engine is on) but im not sure about the factory 10 pin harness I just got. Will I need to get all yam parts for my dash to get everything to work. <br /><br />I have a binicle control box that has wires for the tilt trim, but the harness has only two plugs on the end. I'd hate to cut and strip this. <br /><br />So I guess my question is, how do I rig the tach trim/oil and the start switch and then the tilt trim when there is only 2 plugs at the end of my harness. Am I missing a harness?<br /><br />Thanks<br /><br />Mike

 

[esteym]

Re: Yam 150 wiring

I just re-read rodbolts reply to a message I left a while ago. I need a main harness (got it), alarm harness, oil tank harness (this one comes with the oil tank kit I got i think).<br /><br />So on the two plugs at the end of the ten pin harness... one goes to the tach while the other goes to the ignition?<br /><br />What about tilt trim?<br /><br />Thanks!<br /><br />Mike

 

[rodbolt]

Re: Yam 150 wiring

does tour binnicle have a trim switch?<br /> trim switch binnicle harness will use a 5 pin pigtail. 2 browns for neutral start a red power and lt blue for up and lt green for down. if you buy all the correct stuff its plug and play.<br /> at the swicth end of your main 10 pin harness. one plugs into the ign switch assy the other into the correct binnicle pigtail.

 

[esteym]

Re: Yam 150 wiring

Thanks Rodbolt,<br /><br />I went to the shop around the corner and through the woods, and they told me the same thing. Use all yamaha and you wont be sorry. SO I feel a little better about the 600 bucks I just droped on the binicle start switch and a few other things.<br /><br />Ive got everything figured out now and should be good to go. Thanks for all the info.<br /><br />Mike