Hello again from the not so sunny British Isles
I have finally got my Evinrude 40hp twin to burst into life!!
After installing new coil - new plugs - cleaned and set points and replaced sheared woodruf key (3 times in process).
I can now get motor to fire up at med to high revs but it wont idle or keep running at low revs.
poked bit of wire up the jet.:facepalm:
also smells very fuel rich and lots of smoke on start up. needs full choke and even choke to start when quite warm??
Can anyone offer any advice please
thanks Craig
I have finally got my Evinrude 40hp twin to burst into life!!
After installing new coil - new plugs - cleaned and set points and replaced sheared woodruf key (3 times in process).
I can now get motor to fire up at med to high revs but it wont idle or keep running at low revs.
poked bit of wire up the jet.:facepalm:
also smells very fuel rich and lots of smoke on start up. needs full choke and even choke to start when quite warm??
Can anyone offer any advice please
thanks Craig