Wiring trolling motor direct, by passing plug in and charge/run switch

jonorth

Recruit
Thread starter
Joined
Jul 10, 2011
Messages
3
Trolling motor is 70 lb 24 v motor guide (bass pro sells) 5 speed bow mount foot control. 92 astro bass boat has 4 wires (2 pos/2 neg) 6 gage wire w/24 volt stamped on the wire, running from batts w/two 40 amp circuit breakers on each pos wire. These 4 wires go to bow panel plug in and charge/run switch. Old motor guide 54 lb had 12/24 switch on trol mtr foot. I am replacing old mg w/the 24 v 70 lb mg noted above. I think the charge/run and or the plug in was defective as I could not get new mtr to work. So using Silvertips excellent diagram I wired the batts as directed and now have only one 6 ga pos wire/ one 6 ga neg wire, running to the bow panel. I removed the plug in and charge/run switch and wired the trl mtr. directly to the two 6 ga wires. The mtr fired right up and seems to run fine. (no water test, just on boat) This is all new to me so I want to be sure I did the wiring correctly and safetly. This 66 yr old man would really appreciate any advice, have I done this right? Do I need a 50 amp fuse? Any thing else I need to do? Soon I most likely will get a plug and receptacle (which one? please?) The boat places are quite a distance from me and the wait is very long to see a mech/tech. Thank you so much......
 
Top