Wire Rip-Out and Replacement for Dummies

Napy

Recruit
Thread starter
Joined
Jul 7, 2011
Messages
2
Hello. I am new to iBoats.com, but here goes nothing. I own a 20' Center Console Sea Ox, with a Evinrude 175 on the back. Being an Electrician by profession, after pulling out my radio from the dash to figure out why it was not working, I was quickly sickened by the electrical work that I had found inside the console. I continued to dig deeper and deeper, and found that the whole electrical system was pretty crappy and I could not stand for that. So, over the past few weeks I have slowly but surely pulled just about every piece of wire out from inside the console, all the way back to the batteries. Now I have to replace it all. I am looking for some references to start building my electrical system from scratch. After my last deployment I purchased 2 Optima Red Top Batteries and replaced the 3 batteries of various manufacture. That being said, those are about the only electrical components I really intend to keep in the boat. So I am looking for everything from elementary wiring diagram solutions, that include wire sizing and rating you can expect to be carried to the console, lights, etc. for placing fuses in and what not. I have already copied the two pictures that are stickied at the top of this forum, but I still have questions and I figure this would be a good place to start. Any help would be greatly appreciated, and I look forward to using this site more often now that I have found it.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Wire Rip-Out and Replacement for Dummies

If you look at the "stickies" at the top of this forum you will find a "Generic Boat Wiring Diagram". That diagram represents how the vast majority of small boats are wired. 16 gauge wire is fine for nearly every accessory on the boat. High current draw items obviously require larger wire. The engine wiring is covered in the service manual for your specific engine. Understand that there are two electrical systems in a boat. The engine is obviously one of them. 12 volts is fed to the engine via the large battery cables. From there it goes to the helm via the engine harness. The ONLY accessories fed from this system are the instruments. The engine harness is NOT designed to handle the remainder of the boats electrical load. You then run a pair of #8 or #10 wires (red & black) via a breaker to fuse/breaker panel at the helm. That panel feeds the switches and related accessories. If you run dual batteries, you need a dual battery switch, automatic charge relay (ACR) or isolator all of which are discussed to death in this forum. Use the SEARCH feature.
 

seabob4

Lieutenant Commander
Joined
Jun 10, 2008
Messages
1,603
Re: Wire Rip-Out and Replacement for Dummies

I do complete re-wires for a living. Here is a link to my photobucket account that shows you how I do things...http://s259.photobucket.com/home/seabob4/index If you click on "All Albums", it will show you the various boats I've done, what they looked like when I got them, what they looked like when I finished. You also might open the "Wiring Diagrams" album, some drawings I've done dealing with switch panels, battery set-ups, bilge wiring, etc.

PM me if you want some guidance...:)
 

Napy

Recruit
Thread starter
Joined
Jul 7, 2011
Messages
2
Re: Wire Rip-Out and Replacement for Dummies

Thanks for all the great info guys. This all should get me started. And Seabob, look like you have done some great work.
 

seabob4

Lieutenant Commander
Joined
Jun 10, 2008
Messages
1,603
Re: Wire Rip-Out and Replacement for Dummies

I do my best...
 
Top