skydiveD30571
Lieutenant Junior Grade
- Joined
- Feb 13, 2012
- Messages
- 1,042
I'm posting this here because it is my understanding that most carbed engines need a crack of throttle to warm start and that it is normal, so there is probably no repair needed.
I'm wondering why this is required though. In my case specifically with a 2006 5.0GL-H with Holley 2bbl 2300, I have always had great luck starting both cold and warm with a little throttle. Even 3 or 4 days of sitting without running, just a 1/4 to 1/3 throttle and turn the key and it starts right up. Throughout the day it's the same way. Just for kicks yesterday I tried several times without giving throttle. I noticed that it gets progressively worse the longer it's been off. After running engine to operating speed then turning off:
1) wait only a couple seconds then turn on again - fires right up and idles smooth.
2) wait 30 seconds to a couple minutes - fires up but idle settles a little low then speeds up and smooths out like normal
3) wait a couple minutes to 30+/- minutes - more cranking needed and then fires up, but more of a stutter start with low loping rpm's. Usually doesn't clear unless throttle is given then backed down to idle again. Then runs smooth.
4) wait more than half an hour - doesn't want to fire unless throttle is given.
I also noticed that the longer it sits off, the more the throttle needs opened to start. I usually start at 1/4 throttle and turn the key, then advance throttle slowly until it catches then back it off. Like I said, I understand that throttle is usually needed for warm starts, but what is the reason? Evaporating fuel so that fuel from transfer slots is needed to start? Carb slowly leaking fuel/vapor so more airflow is needed to clear slightly flooded condition? Not enough air flow at idle? Something going on in the engine itself? These are general questions since this is a common occurance it seems like. Any theorys or ideas or facts are appreciated!
I'm wondering why this is required though. In my case specifically with a 2006 5.0GL-H with Holley 2bbl 2300, I have always had great luck starting both cold and warm with a little throttle. Even 3 or 4 days of sitting without running, just a 1/4 to 1/3 throttle and turn the key and it starts right up. Throughout the day it's the same way. Just for kicks yesterday I tried several times without giving throttle. I noticed that it gets progressively worse the longer it's been off. After running engine to operating speed then turning off:
1) wait only a couple seconds then turn on again - fires right up and idles smooth.
2) wait 30 seconds to a couple minutes - fires up but idle settles a little low then speeds up and smooths out like normal
3) wait a couple minutes to 30+/- minutes - more cranking needed and then fires up, but more of a stutter start with low loping rpm's. Usually doesn't clear unless throttle is given then backed down to idle again. Then runs smooth.
4) wait more than half an hour - doesn't want to fire unless throttle is given.
I also noticed that the longer it sits off, the more the throttle needs opened to start. I usually start at 1/4 throttle and turn the key, then advance throttle slowly until it catches then back it off. Like I said, I understand that throttle is usually needed for warm starts, but what is the reason? Evaporating fuel so that fuel from transfer slots is needed to start? Carb slowly leaking fuel/vapor so more airflow is needed to clear slightly flooded condition? Not enough air flow at idle? Something going on in the engine itself? These are general questions since this is a common occurance it seems like. Any theorys or ideas or facts are appreciated!