Moody Blue
Captain
- Joined
- May 24, 2004
- Messages
- 3,136
Adding a fish finder to an older deep V fiberglass boat (Wilker). Have the transducer and a speed wheel (with temp sensor) for trolling along with the original pitot tube for the speedo.
Any experience with how close I can install these parts to each other.
Currently the pitot is about 18" to starboard of the motor. Planning on putting the speed wheel on port side about 18" from motor. Can't see a good spot for the transducer other than next (6") to the pitot tube. Will they interfere with each other do you think (turbulence)?
Any suggestions?
Any experience with how close I can install these parts to each other.
Currently the pitot is about 18" to starboard of the motor. Planning on putting the speed wheel on port side about 18" from motor. Can't see a good spot for the transducer other than next (6") to the pitot tube. Will they interfere with each other do you think (turbulence)?
Any suggestions?