What Bearing Puller?

[Tsteiny]

Trying to replace the top cover bearing cup on the upper drive shaft after replacing the seals. The race has some pits in it. In the manual I only see the parts number for the puller rod? I can’t seem to find any pullers that will fit so I can actually pull the bearing cup out. What did you guys use to pull it out? Can a I simple OTC slide hammer you can’t rent from auto zone work

 

[dubs283]

Can a I simple OTC slide hammer you can’t rent from auto zone work

This is what I use. Need to clamp the top cap in a vise with rags as not to damage the finish

Get a slide hammer with multiple jaws, need to be smaller/modified to fit under the race securely. Shims can be damaged on removal so be prepared to replace one or more

 

[alldodge]

Trying to replace the top cover bearing cup on the upper drive shaft after replacing the seals. The race has some pits in it. In the manual I only see the parts number for the puller rod? I can’t seem to find any pullers that will fit so I can actually pull the bearing cup out. What did you guys use to pull it out? Can a I simple OTC slide hammer you can’t rent from auto zone work

Blind hole bearing puller if I understand you correctly
https://www.amazon.com/blind-bearing-puller/s?k=blind+bearing+puller

 

[kenny nunez]

Another trick is to heat the outer area of the cover and the cup will drop out.

 

[Tsteiny]

Another trick is to heat the outer area of the cover and the cup will drop out.

Seriously? How well does that work? That would be a millions times easier

 

[kenny nunez]

A propane torch should do it if you do not have an oxy/acetelyne rig. It usually does not take much heat to make it happen.