I'm replacing the trim sensor in a DP-E drive and wondered if someone could tell me where the o ring should be installed?
The old one had the o ring rolled up against the top plate of the sensor, but I noticed there is a groove in the sensor that looks like it was made for an o ring. The o ring that was supplied for the sensor is much narrower than that groove.
Where the heck is it supposed to be installed?
The old one had the o ring rolled up against the top plate of the sensor, but I noticed there is a groove in the sensor that looks like it was made for an o ring. The o ring that was supplied for the sensor is much narrower than that groove.
Where the heck is it supposed to be installed?