I have an 86 Eliminator with a 350 Chevy and a Volvo outdrive. The boat has sat since 2001/2 and I finally got it tuned up and ready for the water. On my trial run everything ran fine except the outdrive wouldn't trim up/down unless I was under 10mph. At the end of the day, I was pulling into dock and I pulled it into reverse to slow up, and the boat went forward. Now the prop will only spin freely in the forward direction without the engine running (I don't know if it ever spun freely both ways). The other problem, is with the button that engages the drive pulled out, the prop now spins when I start the engine, in what is supposed to be nuetral, no prop engage.<br />I would appreciate any advice, the trim up/down is the last of my worrries. Thanks