voltmter, what the?

Hoosier D

Recruit
Thread starter
Joined
Jul 25, 2011
Messages
5
Hi, I'm new at this forum stuff so please bear with me.
I have a 2005 17 ft. Tiderunner that hasn't been started in several months. Well I got the batteries charged up, and now when I try to start the motor, I sometimes get my usual pre-ignition beep, and sometimes not. Or if I do and turn the key, I may get a silinoid click or the engine may even kick over, or the ignition goes dead. As far as the gauges go, well the voltmeter needle is now on the wrong side of the peg!!!??? the tach gauge will pop up to about 3000rpm, (no the motor isnt running), and then drop to nothing. And I do have dual batteries with selector switch. Any guesses as to what may be the cause?:confused:And no I'm not electrically minded.
 

produceguy

Lieutenant Junior Grade
Joined
Sep 30, 2010
Messages
1,243
Re: voltmter, what the?

Did you have any problems before or do any rewiring?
I would start at the starter and check all connections and grounds.
 

Fireman431

Rear Admiral
Joined
Sep 17, 2007
Messages
4,292
Re: voltmter, what the?

It sounds (reads) like bad connections. This is the sucky part. Start at the battery. Remove the terminal connections, clean with a bit of sand paper till they're shiny, reconnect and make sure they are tight. Coat with corrosion inhibiter spray. Move to the next connection. Repeat. Move to the next connection. Repeat.

Stop when you have finished the gauges. I'm willing to bet all your gremlins go away after that. I did that to my last boat (took 4 hours) and sprayed everything with the red/pink battery terminal anti-corrosion spray. In 3 years, never had another electrical issue. Now all my connections get the treatment.
 

Hoosier D

Recruit
Thread starter
Joined
Jul 25, 2011
Messages
5
Re: voltmter, what the?

Did you have any problems before or do any rewiring?
I would start at the starter and check all connections and grounds.

No, no problems like this and no wiring done. I did put some dielectric grease on most of the connectors fuses etc. with no change.
 

Hoosier D

Recruit
Thread starter
Joined
Jul 25, 2011
Messages
5
Re: voltmter, what the?

Thanks for your help, I have some of that spray too, I'll give that a try as well.
 

Hoosier D

Recruit
Thread starter
Joined
Jul 25, 2011
Messages
5
Re: voltmter, what the?

Oops! sorry for posting in the wrong section.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: voltmter, what the?

Did you have the batteries out of the boat for any reason, and then hook the cables up wrong? One of the reasons the needle on the volt meter is on the wrong side of the peg is because reversed polarity at the batteries will cause the meter to read backwards so the needle jumped over the peg. There is a + and - on a battery for a reason.
 

Fireman431

Rear Admiral
Joined
Sep 17, 2007
Messages
4,292
Re: voltmter, what the?

No, no problems like this and no wiring done. I did put some dielectric grease on most of the connectors fuses etc. with no change.

Putting the grease on the connections doesn't do any good unless you cleaned all connections first.
 

Hoosier D

Recruit
Thread starter
Joined
Jul 25, 2011
Messages
5
Re: voltmter, what the?

nope didn't have them out and made sure after i charged them that they were hooked upp correctly.
 
Top