Hello, looking for help please. Have a VP
SX-A 1.60. I’ve replaced the trim sensor with aftermarket sensor. No matter what I do I can only get use of 3/4 of the gauge travel. It either works from full up to 3/4 the way down or from full down to 3/4 up (gauge needle travel). Am I doing something wrong or did I just get a sensor that is not up to specs. The part number I purchased is 21484383. It has not been in the water yet. Also trim worked fine til some type of animal chewed up the wiring along with the trim hoses. Thank you in advance.
SX-A 1.60. I’ve replaced the trim sensor with aftermarket sensor. No matter what I do I can only get use of 3/4 of the gauge travel. It either works from full up to 3/4 the way down or from full down to 3/4 up (gauge needle travel). Am I doing something wrong or did I just get a sensor that is not up to specs. The part number I purchased is 21484383. It has not been in the water yet. Also trim worked fine til some type of animal chewed up the wiring along with the trim hoses. Thank you in advance.