I have a 1973 Jolly roger with a 888 ford and mc1 outdrive serial 316xxxxx (the rest of the label is missing). It had a trim sensor on the inside of the transom that ran off the hydraulic lines. I disconnected it as the electrical was not any good. Now I dont remember where it went and what line went where. I purchased one that is guaranteed to work off of ebay and I want to install to see if it allows my outdrive to go into full up position.
If anyone can find a picture of a boat with this setup so that I can copy I would be so grateful.
If anyone can find a picture of a boat with this setup so that I can copy I would be so grateful.