Hi Everyone,
I did my bi-weekly check on my winterized boat yesterday and noticed that water has entered through the anchor chain hole and has created the condition shown in the attached photo. I've "stopped the bleeding" by covering up the hole where water was entering, but Is there a secret to fixing the stains that the water leaking on a red trim piece has caused? I'm shocked that this could happen in only a week or 2, but its been raining like crazy here. I'm running air/heat through the cabin to completely dry everything out.
Everything is solid and I've never once experienced a leak issue in the cabin, so I'm not worried about major damage (or at least I dont think I should be), but is there a trick to removing these stains?
Any insight is greatly appreciated!
I did my bi-weekly check on my winterized boat yesterday and noticed that water has entered through the anchor chain hole and has created the condition shown in the attached photo. I've "stopped the bleeding" by covering up the hole where water was entering, but Is there a secret to fixing the stains that the water leaking on a red trim piece has caused? I'm shocked that this could happen in only a week or 2, but its been raining like crazy here. I'm running air/heat through the cabin to completely dry everything out.
Everything is solid and I've never once experienced a leak issue in the cabin, so I'm not worried about major damage (or at least I dont think I should be), but is there a trick to removing these stains?
Any insight is greatly appreciated!
