I have the Command Link Multifunction Meter (Square) for tach and one for speedo/fuel management. I tried to re-set the trim gauge to zero, because it was off by 1-2 bars when trimmed fully down. Followed the instructions on page 13 of the Command Link Operation Manual(part#6y8-2819U-00). Now the indicator does not show any movement when the trim/tilt is used. Stays at one bar.
Have I misunderstood the purpose of the 0Set (to set put the gauge at 0 when full down, right?) or have I missed a step? Any help will be appreciated.
david
Have I misunderstood the purpose of the 0Set (to set put the gauge at 0 when full down, right?) or have I missed a step? Any help will be appreciated.
david