TILT AND TRIM WIRING DIAGRAM FOR A 1987 85HP FORCE

[imported_fullforce]

HI GUYS , JUST WONDERING IF ANYONE CAN SEND ME A WIRING DIAGRAM FOR THE TILT AND TRIM FOR A 1987 85HP FORCE , TILT MOTOR IS A 2 WIRE SYSTEM . THANKS IN ADVANCE

 

[JUSTINTIME]

Re: TILT AND TRIM WIRING DIAGRAM FOR A 1987 85HP FORCE

what is the problem?

blue-up
green-down

find the two relays
red is the 12v
black is the ground

the motor grounds out through the other relay, unless u have 2 solenoids

 

[imported_fullforce]

Re: TILT AND TRIM WIRING DIAGRAM FOR A 1987 85HP FORCE

what is the problem?

blue-up
green-down

find the two relays
red is the 12v
black is the ground

the motor grounds out through the other relay, unless u have 2 solenoids

my boat did not had any relays or circuit breaker which i had to buy , this is my first time hooking up the system so i needed some advice. thanks justintime , i connected them yesterday and everything works fine.

 

[JUSTINTIME]

Re: TILT AND TRIM WIRING DIAGRAM FOR A 1987 85HP FORCE

no problem

 

[829]

Re: TILT AND TRIM WIRING DIAGRAM FOR A 1987 85HP FORCE

I have this same engine and do not have power tilt/trim, I take it from your post you manually added it? Was this an easy project?

 

[imported_fullforce]

Re: TILT AND TRIM WIRING DIAGRAM FOR A 1987 85HP FORCE

hi 829
i bought my bayliner with a bad tilt and trim system, i found a good complete t&t system on ebay and bought it, since i already had a bracket on my boat i took off the cylinder + shock absorber and trim off the new bracket and assembled it back in the boats bracket, it was real easy to do,

 

[829]

Re: TILT AND TRIM WIRING DIAGRAM FOR A 1987 85HP FORCE

Thank you, mine has the man powered t&t system, I have to lift, release bracket, and lower. I looked at a few systems here on iboats and I just cannot afford it at the moment, but it is something I may do next year.

Thanks again for getting back to me.