Hi again.
I finally managed to remove the cover on my tilt motor, as it was not working.
The tilt/trim cylinder/motor was mounted on a spare motor I got when I purchased my DT-40. It would be sweet to have a tilt on my motor.
Im hoping that there are someone here that can tell me if its doable to repair
the tilt motor I have, brushing of the rust, and cleaning it, hopefully that can
make it work again?. I took a short 2min film of the motor.
See the youtube link below, any help would be appreciated, im pretty new to
repairing "alternators", which im guessing this almost is..
https://www.youtube.com/watch?v=DPGUa0WuVCU
I finally managed to remove the cover on my tilt motor, as it was not working.
The tilt/trim cylinder/motor was mounted on a spare motor I got when I purchased my DT-40. It would be sweet to have a tilt on my motor.
Im hoping that there are someone here that can tell me if its doable to repair
the tilt motor I have, brushing of the rust, and cleaning it, hopefully that can
make it work again?. I took a short 2min film of the motor.
See the youtube link below, any help would be appreciated, im pretty new to
repairing "alternators", which im guessing this almost is..
https://www.youtube.com/watch?v=DPGUa0WuVCU