Superwilly
Recruit
- Joined
- Jul 5, 2012
- Messages
- 5
Hi all, I have a 1950's 15' aluminum Aroliner made in St. Boniface, MB. It was originally a console-steer runabout, but I've cut the bow back, and removed the console. I'm gonna turn it into a vintage fishing boat with a tiller.
I need an outboard, would this be suitable? I have an electric trolling motor off the back, is 33hp too much for my boat?
http://www.swanvalleyclassifieds.ca/ind ... a=2&b=4225
Also, I think I need short shaft as my transom is only about 16 inches. Does that Evinrude look to be short shaft? Are there any parts available for an oldie like that, or do I just hope it stays together. What is reliability like for those older outboards?
I like the fact that this old engine will kinda match the vintage lines of my boat. If it runs well, I may snag the engine and then just sell the fiberglass boat/trailer.
Thanks for any advice!
-Cam
I need an outboard, would this be suitable? I have an electric trolling motor off the back, is 33hp too much for my boat?
http://www.swanvalleyclassifieds.ca/ind ... a=2&b=4225
Also, I think I need short shaft as my transom is only about 16 inches. Does that Evinrude look to be short shaft? Are there any parts available for an oldie like that, or do I just hope it stays together. What is reliability like for those older outboards?
I like the fact that this old engine will kinda match the vintage lines of my boat. If it runs well, I may snag the engine and then just sell the fiberglass boat/trailer.
Thanks for any advice!
-Cam