Starting issues... Replaced starter, issue not fixed

Allenhowes

Recruit
Thread starter
Joined
Jul 9, 2016
Messages
3
Hello all, long time lurker. I have recently picked up on older (92?) Evinrude 48spl. After some tlc and tinkering it's been running well. We went out yesterday and after starting fine a few times I went to crack it and the starter didn't want to turn it over. It made a strange, almost grinding sound, so I figured the starter bearing was shot. The bendix wouldn't go up or down sometimes, so I figured new starter no problem.

New starter arrived today, same thing.

I think my next course of action is to check the block connections? Could it not be getting enough juice?

The flywheel spins by hand, the motor turns fine.

What am I missing?
 

Roj115

Petty Officer 2nd Class
Joined
Aug 21, 2004
Messages
102
Just making a wild guess here but I'm wondering if the battery is too weak to start the motor. If you were running the motor and the battery lost charge that would point to a flaky rectifier. Try charging the battery up and then try starting it. If charging it solves the problem then you need to diagnose your charging system and my first guess would be the rectifier.
 
Last edited:

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
Try jumping the starter direct to a known good battery with a set of automotive jumper cables. If the starter cranks normally, it's ok-so you should have a look at the starter solenoid. When the starter solenoid gets really old and has had high start cycle counts, the solenoid can be the problem. With high cycles, the internal tips of the solenoid get burned and won't transfer enough current to spin the starter normally. You may need to replace it.
 

Allenhowes

Recruit
Thread starter
Joined
Jul 9, 2016
Messages
3
Took the batteries out and charged them, they both were low. After charging the first it cranked right up. So I guess I'm replacing the rectifier and solenoid. There is only one thing connected directly to the batteries, I'll start disconnecting it while the boat is yarded from now on.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Before you replace stuff, start the engine, run it at about 1500 rpm and measure the voltage at the battery. If less than 13.5 volts the battery is not charging. If between 13.5 and 14.5 volts the battery is charging but it may not be capable of holding a charge. You need to have it load tested and if ok, then look at wiring. If that's ok, then the charging system.
 
Top