Replaced bellows & have an extra part?

[ShawnR]

1990 Cobra outdrive on a Four Winns boat.

I just finished replacing the gimbal bearing & bellows and got everything all buttoned up. During the clean up process and putting tools away, I found an extra nylon locking nut and I can't figure out where it came from.

10mm nut size with M6-1.0 thread pitch.

I have looked through the diagrams and can't see where it would come from either.

Any thoughts? I suppose it is possible that it was in the toolbox from a previous project, but I am usually pretty good about those things.

 

[Idlespeedonly]

Re: Replaced bellows & have an extra part?

More than likely not from your project. Most if not all fasteners on the cobra are SAE and not metric.