Removing lower unit to replace water pump

[Bryanjlb]

I am trying to replace a water pump on a 1983 Johnson 35 hp. The lower unit only dropped about a half inch. I can not find the pin to release the linkage to get the lower unit to come out. Does anyone have an idea that can help me get this lower unit off.

 

[oldcatamount]

Re: Removing lower unit to replace water pump

The shift rod sections are held together with a connector nut. If the lower unit is down by 1/2 inch, you should be able to see it. Also, there's a "keeper" in there, inside the nut casing.

 

[carholme]

Re: Removing lower unit to replace water pump

This might help you. It is a link to the condensed version of the Clymer manual. Download it soonest to your computer as the link is short lived.

Small Engine Repair Reference Center Home: OUTBOARD MARINE CORPORATION - EVINRUDE AND JOHNSON 28 HP (1987-1989), 30 HP...

See page 360, REMOVE AND REINSTALL and figure OM11-26 which applies to models post 1979.

Gerry

 

[classiccat]

Re: Removing lower unit to replace water pump

I have the 35hp '83 evinrude; the shift-rod connection is behind the plastic water intake screens.

 

[Bryanjlb]

Re: Removing lower unit to replace water pump

Thanks for all the help guys. New to this site and I have to say i give it a 5 star rating. It was right behind the water intake screens. looking foward to bettering my boat with this site. Thanks guys.